Whats the best way to lower my s10 but still make it dragable..its a 1988 so whats the best way...

"Dragable"? Do you mean scraping on the ground or drag racing?

Rear tubs, cut up the bed, 2 link, big ass bridge notch, some SS bags and 1/2 lines

Fill it with nitrogen and it will slam quick as ****

I would lower the front about 3-4 inches......using a 2" Belltech drop spindle, and a 1" or 2" drop coil. In the rear, I would install AT LEAST a 4-link with some 2600lb Firestone air bags.........1/2" single ports, run 175-200 psi, should only need a 5 gallon air tank, 1 compressor (either an Arizona or a Vaiar 480), all 1/2" line, and 4 SMC 1/2" valves, a 175-200 psi pressure switch, and a moisture trap.

thx for the help lowred for the info..aprox..how much would that run me..oh and ObseSSed i ment drag race able..

I would guess around $900-$1100 for the rear, and spindles are usually around $200, and springs should be like $70 or so...............

ok thx thats not bad...1200 is good

Go to www.suicidedoors.com or www.innovativeair.com for the rear setup you'll need. The spindles and springs you can get anywhere that sells Belltech..........