hi,can anyone tell me how to program my alarm keyfob to my car.i blew a fuse fitting amy stereo and it has'nt worked since.its two button type and my car is a 2001 bora(jetta).thanx

Did you look in your owner's manual for instructions?


I can't seem to find instructions for a Bora, but I was able to find instructions for a Jetta, you might want to try it and see if it works as most manufacturer's use the same programming method for a range of their vehicles.



----------------------

Note: This requires two car keys and a wireless remote.

1. Put the 1st key in the car's ignition. Turn the key so that the electrical system comes up, but don't start the engine.

2. Get out of the car and close the car door.

3. Put the 2nd key in the drivers side door and lock the door.

4. Turn the key in the drivers side door to the left and hold it there until the car beeps 3 times. (this enables programming mode)

5. On the wireless remote, push the Lock, Unlock and Trunk buttons.

6. Once again, turn the key in the drivers side door to the left and hold it there until the car beeps 3 times. (this disables programming mode)

ahhh Mikes the greatest. Saved me from doing anything....^^^what he said should work. Let us know how it goes

hi.thanx for advice i tried this method a couple of times but nothing happened.the central locking works if i use my key in either door and i know the keyfob batteries are ok,any ideas what else i can try.thanx